// topic

3D Printing

All about 3D printing

13 posts

tags: All 3d-printing 3d-druck ai bed-mesh bondtech btt-eddy btt-octopus can-toolboard can-bus claude corexy debugging descend_z direct-drive dragon-burner endschalter extruder fehlersuche firmware freecad gt2 hevort hotend idler kalibrierung klipper ldo-orbiter led_effect linux maker mcp neopixel openscad orcaslicer phaetus-rapido pressure-advance print-in-place skew_correction slicing spare-part status-led timing-belt sort: neueste · beliebt

Seven fallacies from real Klipper troubleshooting: a plausible CAN hypothesis that was wrong, a config without effect, a …

34 % print time saved, measured rather than estimated: Z-hop as the most expensive item, layer height and …

Measure and correct XY skew with Klipper skew_correction: why only the diagonals reveal a skewed printer, how a …

Layer shift on the B diagonal, grinding during homing: two endstops on one belt twisted the X gantry …

In print-in-place models, the position of the slice planes decides whether joints stay movable. Why finer layers make …

A bed mesh without zero_reference_position doesn't act as a shape correction but as a constant 0.14 mm offset. …

With the Klipper update 2026, z_offset in the probe_eddy_current block was marked as deprecated and replaced by descend_z. …

How I hooked the FreeCAD Robust MCP Bridge Server up to Claude Code on Linux – and had …

A custom X-carriage for the HevORT that holds the Dragon Burner: stable and universal rather than tuned for …

Printer status at a glance: three Neopixels on the toolhead show homing, heating, printing and standby using the …

Honest field report: why my cheap Bondtech-clone extruders jammed after a few months in a Bowden setup – …

Upgrading a Klipper printer (BTT Octopus) with the Phaetus Rapido 2F high-flow hotend: mounting, PT1000 wiring, PID tuning …

‹ newer Page 1 / 2 older ›